Delphi FJ10062 Fuel Injector

Delphi FJ10062 Fuel Injector Review

Delphi FJ10062 Fuel Injector Feature

• Accurate, tightly controlled fuel spray pattern for more efficient fuel vaporization, reducing unburned hydrocarbon emissions
• Internal seal rings protected from fuel exposure, minimizing in-use "sticking" for longer-lasting durability
• Improved sealing materials, providing cold sealing to -40 degrees C for better cold starts
• Mulitifuel capability

Delphi is an original equipment brand that partners with other manufacturers to supply the parts your car was originally built with. This product is in a Delphi package, note that the part may have been manufactured by an independent Delphi supplier.

Chevron Techron Fuel System Cleaner, 20 oz. (65740)

Chevron Techron Fuel System Cleaner, 20 oz. (65740) Review

Chevron Techron Fuel System Cleaner, 20 oz. (65740) Feature

• Helps restore fuel efficiency
• Helps restore lost power and drivability
• Protects fuel gauge from malfunctioning by coating all metal surfaces.
• Helps prevent engine knocks and pings
• Cleans chambers, intake valves, ports, and injectors

Chevron Techron Fuel System Cleaner is unbeatable in cleaning the entire fuel system and restoring lost power and performance caused by deposit build-up.

Cleans deposits from fuel injectors, carburetors, ports, valves and combustion chambers

Works in one tankful while you drive to reduce deposit related engine knock, ping, run-on, and cold start problems

Recommended for use every 3,000 miles

20 oz. bottle.

AUS Injection MP-50102 Remanufactured Fuel Injector

AUS Injection MP-50102 Remanufactured Fuel Injector Review

AUS Injection MP-50102 Remanufactured Fuel Injector Feature

• Remanufactured In the USA
• All units are 100% factory tested before packaging
• Clean injectors provide better gas milage and increase overall performance
• All injectors are lubricated prior to packaging ensuring a trouble free installation
• All injectors are backed by a 12 month 12,000 mile warranty

Quality remanufactured fuel injectors that are electronically tested for correct electrical resistance and for coil weakness. Good units are then disassembled (micro filter, seals, pintle caps and plastic spacer are removed.) Injectors are simultaneously cleaned in ultrasonic tanks specially designed to clean fuel injectors. All units are individually back flushed to remove the broken dirt particles, these particles can not be removed thru the injection orifices therefore are driven out thru the inlet of the injector. All injectors are then mounted on the flow bench in an inverted position to allow them to reverse flow at a considerable pressure. We run a high performance injector cleaning solvent thru the injectors for 30 minutes, completing the cleaning process. This process assures all dirt particles are completely removed from the injector. Injectors are now mounted on the flow bench in the correct position to begin the testing procedures. We apply 60 PIS of pressure (more than a regular multi-port fuel injection system) and maintain the injectors with no signal to them for 30 seconds to make sure there are no leaks. Depending on the original manufacturer presentation, the injectors are either painted or polished to give the best cosmetic appearance possible. Injectors are then assembled with new replaceable components (filter baskets, pintle caps, O-rings and seals) and a final test is performed with all new components on injectors. The purpose of this test is to make sure the filter basket; o-rings, seals and pintle caps are positioned correctly and are not disturbing the flow or the spray pattern of the injector. Injectors are lubricated with special oil and protective caps are placed on both ends to extend the shelf life and assure that when they are installed in the vehicle they will be in optimum operating condition. Each injector is individually bagged.